Setting The Osd Language - Onkyo DV-SP800 Instruction Manual

Setting Up the Player
Using the Setup Navigator
I Setting the OSD Language
(On-Screen Display Language)
The [OSD Language] screen establishes the OSD language,
or on-screen display language, which refers to the language
that is used by the player in menus and on-screen messages.
Additionally, the language that is established at this setting will
also be used for the default audio and subtitle language.
Audio1 A2 Video1 V2 Language General
Setup Navigator English
français
Deutsch
Language
Italiano
OSD Language
Español
Select the On Screen Language
Move Select
ENTER
Settings: English (Factory setting)
français
Deutsch
Italiano
Español
Notes
• The languages that can be selected may be different from those
shown above.
• In addition to setting the [OSD Language], the audio and subtitle
language are also set at this time. If you wish to change the
audio or subtitle language to a different language, make changes
in the Setup screen Language menu [Audio Language] and
[Subtitle Language] as needed (pages 57, 58).
I Setting the TV screen size
The [TV Type] screen establishes the size, or more
appropriately the width to height ration of your television or
monitor. The width-to-height ratio of conventional TVs is 4:3,
while the width-to-height ratio of wide screen and high-
definition TVs is 16:9. This width-to-height ratio is called the
aspect ratio.
Audio1 Video1 V2 Language General
A2
Setup Navigator
TV Connection
TV Type Widescreen(16:9)
Standard(4:3)
Widescreen TV
16:9 aspect raito
Move ENTER Select
Settings: Widescreen (16:9) (Factory setting)
Standard (4:3)
Note
There are two screen formats that can be used to display
wide-screen format DVDs: letter box and pan & scan. When
[Standard (4:3)] is selected in the Setup Navigator, the letter box
screen format is automatically selected. To switch the preference to
the pan & scan format, make changes in the Setup screen Video 1
menu [TV Screen] setting (page 52).
22
Exit
SETUP
SETUP Exit
I Setting the type of analog audio
connections
The [Amp Connection] screen establishes the type of analog
audio connection you made to your amplifier/receiver.
Audio1 A2 Video1 V2 Language General
Setup Navigator
Amp Connection 2 ChannelDolby Digital/DTS
Analog Jacks 5.1Channel
Not Connected
2channel jacks for L/R
Move Exit
ENTER Select SETUP
Settings: 2 Channel (Factory setting)
5.1Channel
Not Connected
If you select [5.1Channel] audio connection, confirm which
speakers are connected to your amplifier.
Audio1 A2 Video1 V2 Language General
Setup Navigator
Amp Connection
Center Speaker PresentDolby Digital/DTS
Not Present
Center speaker is connected
to an amplifier
Exit
Move ENTER Select SETUP
Audio1 V2 Language General
A2 Video1
Setup Navigator
Amp Connection
Surround Speakers PresentDolby Digital/DTS
Not Present
Surround speakers are connected
to an amplifier
Move Select Exit
ENTER SETUP
Audio1 V2 Language
A2 Video1 General
Setup Navigator
Amp Connection
Sub–woofer PresentDolby Digital/DTS
Not Present
Sub–woofer is connected
to an amplifier
Move Select Exit
ENTER SETUP
Note
If you connected the audio output directly to your TV, choose
[2 Channel].