Cab Controls - Toro 30635 Operator's Manual

Power-Point Port
The power-point port is used to power optional electrical
accessories (Figure 5).
Adjusting the Seat
Seat-Adjustment Lever
Move the seat-adjustment lever on the side of the seat
outward, slide the seat to the desired position, and release the
lever to lock the seat into position
1. Weight gauge
2. Weight-adjustment lever
3. Seat-adjustment lever
Armrest-Adjustment Knob
Rotate the knob to adjust the armrest angle
Seat-Back-Adjustment Lever
Move the lever to adjust the seat-back angle
Weight Gauge
The weight gauge indicates when the seat is adjusted to
the weight of the operator
positioning the suspension within the range of the green
region.
(Figure 6).
Figure 6
4. Seat-back adjustment
lever
5. Armrest-adjustment knob
(not shown; located under
arm rest)
(Figure
(Figure
(Figure 6). Adjust the height by
Weight-Adjustment Lever
Use this lever to adjust to the proper weight of the operator
(Figure 6). Pull up the lever to increase the air pressure
and push down to decrease the air pressure. The proper
adjustment is correct when the weight gauge is in the green
region.

Cab Controls

1. Air-conditioning switch
2. Air-recirculation control
3. Fan control
Air-Recirculation Control
The air-recirculation control sets the cab to either recirculate
the air in the cabin or to draw air into the cabin from outside
(Figure 7).
•
Set it to recirculate the air when using the air-conditioning.
6).
•
Set it to draw air in when using the heater or fan.
Fan Control
6).
Rotate the fan control knob to regulate the speed of the fan
(Figure 7).
Temperature Control
Rotate the temperature control knob to regulate the air
temperature in the cab
Windshield-Wiper Switch
Use this switch to turn the windshield wipers on or off
(Figure 7).
17
Figure 7
4. Temperature control
5. Windshield-wiper switch
6. Blank switches for optional
kits
(Figure 7).