Cleaning The Air-Conditioning Assembly - Toro 30635 Operator's Manual

1
Figure 89
In-Cab Air Filter
1. Filter
2. Grate
Figure 90
Rear Cab Air Filter
1. Filter
2. Grate
2. Clean the filters by blowing clean, oil-free, compressed
air through them.
Important: If either filter has a hole, tear, or other
damage, replace the filter.
3. Install the filters and the grate with the thumb screws.
3
3. Screw
1
2
3
3. Screw
Cleaning the Air-Conditioning
2
Assembly
Service Interval: Every 250 hours (more frequently in
1. Perform the pre-maintenance procedure; refer to
Preparing the Machine for Maintenance (page
2. Disconnect the wire for each fan.
g028378
1. Fan
2. Wire
3. Remove the 2 knobs and remove the fan assembly.
4. Open the 4 latches on the air-conditioning assembly
and remove the screen.
2
g028379
1. Air-conditioning coil
2. Latch
5. Remove the air filters (see
6. Clean the air-conditioning assembly.
7. Install the air filters, screen, and fan assembly
90, Figure
8. Connect the wire for each fan
64
extremely dusty or dirty conditions).
Figure 91
Right fan shown
3. Knob
Figure 92
3. Air-conditioning screen
Figure 90).
91, and Figure 92).
(Figure
40).
(Figure
91).