Adjusting The Skids - Toro 30635 Operator's Manual

Figure 22
1. Damper link
10. Align the damper-link holes with the selected
height-of-cut bracket holes in the mower-deck frame,
insert the clevis pins, and install the hairpin cotters
(Figure 23).
Figure 23

Adjusting the Skids

Mount the skids in the lower position when operating at
heights of cut greater than 64 mm (2-1/2 inches) and in the
higher position when operating at heights of cut lower than
64 mm (2-1/2 inches).
Note: When the skids become worn, you can switch them to
the opposite sides of the mower by flipping them over. This
allows you to use the skids longer before replacing them.
Adjust the skids (Figure
Important: Torque the screw at the front of each skid to
9 to 11 N∙m (80 to 100 in-lb).
27
24).
Figure 24