Cab Maintenance; Cleaning The Cab; Cleaning The Cab Air Filters - Toro 30635 Operator's Manual

of the mower deck. Continue to check the alignment
of the blades and add shims until the tips of the blades
are within the required dimension.
Important: Do not use more than 3 shims at any 1
hole location. Use decreasing numbers of shims
in adjacent holes if more than 1 shim is added to
any 1 hole location.
8. Adjust the idler pulley and install the belt covers.

Cab Maintenance

Cleaning the Cab

Important: Use care around the cab seals and lights
(Figure 88). If you are using a pressure washer, keep the
washer wand at least 0.6 m (2 ft) away from the machine.
Do not use the pressure washer directly on the cab seals
and lights or under the rear overhang.
1
1. Seal
2. Light

Cleaning the Cab Air Filters

Service Interval: Every 250 hours
1. Remove the screws and grates from both the in-cab
and rear cab air filters
63
2
3
G034330
Figure 88
3. Keep wand 0.6 m (2 ft)
away.
4. Do not pressure-wash
under the rear overhang.
(Figure 89 and Figure
4
90).