Figure 15
1. Turf compensation spring
2. Hair pin cotter
2. Tighten the hex nuts on the front end of the spring rod
until the compressed length of the spring is 12.7 cm
(5 inches) on Reelmaster 5410, 5-inch cutting units or
15.9 cm (6.25 inches) on Reelmaster 5510 and 5610,
7-inch cutting units
(Figure
Note: When operating on rough terrain decrease the
spring length by 13 mm (1/2 inch). Ground following
will be slightly decreased.
3. Spring rod
4. Hex nuts
15).
17