Toro 03675 Operator's Manual page 14

Figure 4
1. Counter weight
5. All the cutting units are shipped with the turf
compensation spring mounted to the right side of the
cutting unit. The turf compensation spring must be
mounted to the same side of the cutting unit as the
reel drive motor. Reposition the turf compensation
as follows:
A. Remove the 2 carriage bolts and nuts securing the
rod bracket to the cutting unit tabs
Figure 5
1. Turf compensation spring
2. Rod bracket
B. Remove the flange nut securing the spring tube
bolt to the carrier frame tab
the assembly.
C. Mount the spring tube bolt to the opposite tab on
the carrier frame and secure with the flange nut.
The bolt head is to be positioned to the outer side
of the tab as shown in
(Figure 5).
3. Spring tube
(Figure 5) Remove
Figure 6.
1. Opposite carrier frame tab
D. Mount the rod bracket to the cutting unit tabs
with the carriage bolts and nuts
Important: On the #4 (left front) and #5
(right front) cutting units
the rod bracket mounting nuts to install the
hose guides to the front of the cutting unit
tabs (Figure
toward the center cutting unit
Figure 9).
1. Hose guide (#4 cutting unit
shown)
2. Rod bracket
14
Figure 6
2. Rod bracket
(Figure
(Figure 7), use
8). The hose guides should lean
(Figure 8
Figure 7
Figure 8
3. Nuts
6).
and