Toro 03675 Operator's Manual page 15

1
1. Hose guides (each must lean toward the center cutting unit)
Note: When installing or removing the cutting
units, make sure the hairpin cotter is installed
in the spring rod hole next to the rod bracket.
Otherwise, the hairpin cotter must be installed in
the hole in the end of the rod.
6. Lower all the lift arms completely.
7. Remove the snapper pin and the cap from the lift arm
pivot yoke (Figure 10).
Figure 10
1. Snapper pin
8. For the front cutting units, slide a cutting unit under
the lift arm while inserting the carrier frame shaft up
into the lift arm pivot yoke
2. Cap
(Figure 11).
Figure 9
1. Lift arm
2. Carrier frame shaft
9. Use the following procedure on the rear cutting units
when the height of cut is above 3/4 inch.
A. Remove the lynch pin and washer securing the lift
arm pivot shaft to the lift arm and slide the lift
arm pivot shaft out of the lift arm
1. Lift arm pivot shaft lynch pin and washer
15
1
Figure 11
3. Lift arm pivot yoke
(Figure
Figure 12
g019284
12).