Installing The Discharge Chute Assembly; Filling The Engine With Oil - Toro Powerlite 38273 Operator's Manual

2
Installing the Recoil Starter
Handle
No Parts Required
Procedure
Install the recoil starter handle in the rope guide as shown in
Figure 5.
1. Rope guide
3
Installing the Discharge Chute
Assembly
Parts needed for this procedure:
1 Discharge chute assembly
2 Screws
2 Washers
2 Locknuts
1 Knob
Procedure
Install the discharge chute assembly as shown in Figure 6.
Figure 5
1. Knob
Note: Install the bolts from the inside of discharge chute
assembly so that the washers and locknuts are on the outside
of the chute.
Important: Do not overtighten the locknuts.
4

Filling the Engine with Oil

Parts needed for this procedure:
1 Bottle of engine oil
Procedure
Your machine does not come with oil in the engine, but it
does come with a bottle of oil.
Important: Before starting the engine, fill the engine
with oil.
Max fill: 12 oz. (0.35 l), type: automotive detergent oil with
an API service classification of SJ, SL, or higher.
Use Figure 7 to select the best oil viscosity for the outdoor
temperature range expected:
6
Figure 6
2. Bolt (2), washer (2), and
locknut (2)