Installing The Discharge Chute And Worm Gear Assembly - Toro 79482 Operator's Manual

Description
Snowthrower assembly
Stop rod
Chute control rod support
Hairpin cotter pin
Snowthrower pulley box
Washer, 15/16 inch
Lift spring
E–ring
Pivot shaft
Stop rod
Cotter pin
Belt
Belt spring
Tension spring
Chute control rod
Hairpin cotter pin
Crank support rod
Locking pin
Cotter pin
Note: It is recommended to install wheel weights and
chains while using this snowthrower. Please contact an
Authorized Service Dealer to acquire a wheel weight kit
and chains.
Installing the Discharge Chute
and Worm Gear Assembly
1. Install the lower discharge chute and deflector shield
onto the housing with 3 carriage bolts (5/16 x 3/4 inch)
(heads to the inside), 3 washers (5/16 inch), and
3 locknuts (5/16 inch) (Fig. 2).
Qty.
1
1
1
1
1
2 Installing the snowthrower to the tractor
2
2
1
1
1
1
Installing the belt and belt spring
1
1 Installing the snowthrower tension spring
1
1
1 Installing the chute control rod and support
1
1
1
4
3
1. Discharge chute
assembly
2. Carriage bolt, 5/16 x
3/4 inch
2. Assemble the upper discharge chute on top and outside
of the lower section with 3 bolts (5/16 x 5/8 inch)
(heads on the inside), 3 washers (5/16 inch), and
3 locknuts (5/16 inch) (Fig. 3).
7
Use
5
2
m–3719
Figure 2
3. Washer, 5/16 inch
4. Locknut, 5/16 inch
5. Chute ring