Table of Contents
Advertisement
Figure 28
1. The oil level is at its
maximum.
2. The oil level is too
high—remove oil from
the crankcase.
Note: You may tip the machine forward (handle up)
a little to make adding oil easier. Remember to return
the machine to the operating position before checking
the oil level.
Important: Do not tip the machine all the way
forward onto its nose, or fuel may leak out of the
machine.
Max fill: 12 oz. (0.35 l), type: automotive detergent oil
with an API service classification of SJ, SL, or higher.
Use Figure 29 to select the best oil viscosity for the
outdoor temperature range expected:
Figure 29
Note: Fill the engine crankcase with oil until the
dipstick indicates that the engine oil level is correct as
shown in Figure 29. If you overfill the engine with oil,
3. The oil level is too
low—add oil to the
crankcase.
remove the excess oil from the drain plug into an oil
drain pan.
9. Screw the oil fill cap into the oil fill hole, and hand
tighten it securely.
10. Wipe up any spilled oil.
11. Dispose of the used oil properly at a local recycling
center.
Servicing the Spark Plug
Service Interval: Yearly—Service the spark plug and replace
it if necessary.
Use a Toro spark plug (Part No. 119-1961).
1. Stop the engine and wait for all moving parts to stop.
2. Disconnect the wire from the spark plug (Figure 30).
3. Clean around the spark plug.
4. Remove the spark plug from the cylinder head.
Important: Replace a cracked, fouled, or dirty
spark plug. Do not clean the electrodes because
grit entering the cylinder can damage the engine.
5. Set the gap on the plug to 0.030 inch (0.76 mm)
(Figure 30).
1. Center electrode insulator
2. Side electrode
6. Install the spark plug and torque it to 20–22 ft-lb
(27–30 N-m).
7. Connect the wire to the spark plug.
16
Figure 30
3. Air gap (not to scale)
Advertisement
Table of Contents
