Installing The Recoil Starter Handle; Filling The Engine With Oil; Installing The Discharge Chute Assembly - Toro 38272 Operator's Manual

2. Installing the Recoil Starter
Handle
Procedure
Install the recoil starter handle in the rope guide as
shown in Figure 4.
1. Rope guide
3. Installing the Discharge
Chute Assembly
1 Discharge chute assembly
2 Screws
2 Washers
2 Locknuts
1 Knob
Procedure
Install the discharge chute assembly as shown in
Figure 5.
1. Knob
Note: Install the bolts from the inside of discharge
chute assembly so that the washers and locknuts are on
the outside of the chute.
Figure 4
Figure 5
2. Bolt (2), washer (2), and
locknut (2)
Important: Do not overtighten the locknuts.

4. Filling the Engine with Oil

1 Bottle of engine oil
Procedure
Your snowthrower does not come with oil in the engine,
but it does come with a bottle of oil.
Important: Before starting the engine, fill the
engine with oil. Do not overfill.
Max fill: 12 oz. (0.35 l), type: automotive detergent oil
with an API service classification of SJ, SL, or higher.
Use Figure 6 to select the best oil viscosity for the
outdoor temperature range expected:
Note: 0W30 synthetic oil is acceptable for use in cold
temperatures.
1. Move the snowthrower to a level surface.
2. Clean around the oil fill cap (Figure 13).
3. Unscrew the oil fill cap and remove it.
4. Slowly pour oil into the oil fill hole, and frequently
check the oil level on the dipstick by wiping the
dipstick clean and then inserting, but not screwing
in, the oil fill cap into the hole.
Note: To determine the proper oil level on the
dipstick, refer to Figure 7.
6
Figure 6