Product Overview - Toro Powerlite 38273 Operator's Manual

Hide thumbs Also See for Powerlite 38273:

Operator's manual (21 pages)

Table of Contents

Adjusting the Control Cable

1. Slide up the spring cover and unhook the spring from

the adjuster link (Figure 10).

Figure 10

1. Adjuster link

2. Z-fitting

Note: You can pull up the adjuster link and cable to

make unhooking the spring easier.

2. Move the Z-fitting to a higher or lower hole on the

adjuster link as needed to obtain the 1/16-inch to

1/8-inch (2 mm to 3 mm) gap between the control bar

and the handle (Figure 10).

Note: Moving the Z-fitting higher decreases the gap

between the control bar and the handle; moving it

lower increases the gap.

3. Hook the spring to the adjuster link and slide the spring

cover over the adjuster link.

4. Check the adjustment; refer to Checking the Control

Cable.

Note: The belt may slip (squeal) in wet conditions;

to dry out the drive system, start the rotor and run it

without a load for 30 seconds.

3. Spring cover

4. Unhook the spring here.