JVC GR-D760EK Instructions Manual page 48

TROUBLESHOOTING
48
EN
Aspect ratio is strange.
If the aspect ratio od the video you are playing is
strange, change the setting in "16:9 OUTPUT".
pg. 36,
( 37)
Displays the battery remaining power.
Remaining power level
High
As the battery power comes close to nil, the
battery remaining power indicator blinks.
When the battery power is exhausted, power
turns off automatically.
TAPE END
Appears when the tape ends during recording or
playback.
LENS CAP
Appears for 5 seconds after power is turned on if
the lens cap is attached or when it is dark.
A. DUB ERROR!
<CANNOT DUB ON A LP RECORDED
TAPE>
<CANNOT DUB ON A 16BIT RECORDING>
<CHECK TAPE'S ERASE PROTECTION
TAB>
● Appears if Audio Dubbing is attempted on a
blank portion of a tape. (
● Appears if Audio Dubbing is attempted on a
tape recorded in the LP mode. (
● Appears if Audio Dubbing is attempted on a
tape recorded in 16-BIT audio. (
● Appears if A. DUB (D) on the remote control is
pressed when the erase protection tab is set to
"SAVE". ( pg. 45)
Exhausted
pg. 45)
pg. 45)
pg. 45)
INSERT ERROR!
<CANNOT EDIT ON A LP RECORDED
TAPE>
<CHECK TAPE'S ERASE PROTECTION
TAB>
<CANNOT EDIT ON A BLANK PORTION>
● Appears if Insert Editing is attempted on a tape
recorded in the LP mode. (
● Appears if INSERT (I) on the remote control
is pressed when the erase protection tab is set
to "SAVE". ( pg. 46)
● Appears if Insert Editing is attempted on a
blank portion of a tape. (
MEMORY IS FULL
Appears when the memory card's memory is full
and shooting is not possible.
SET DATE/TIME!
● Appears when the date/time is not set.
( pg. 16)
● The built-in clock battery has run out and the
previously set date/time has been erased.
HConsult your nearest JVC dealer for
replacement.
UNIT IN SAFEGUARD MODE
REMOVE AND REATTACH BATTERY OR DC
PLUG
Error indications (01, 02 or 06).
Remedy: Remove and reattach the power
supply or battery.
UNIT IN SAFEGUARD MODE
EJECT AND REINSERT TAPE
Error indications 03 or 04.
Remedy: Eject the cassette and re-insert.
In the above 2 error indications, the camcorder
turns off automatically. Eject the cassette once
and re-insert it, then check if the indication
clears. When it does, you can resume using the
camcorder. If the indication remains, consult
your nearest JVC dealer.
pg. 46)
pg. 46)