Time Code; Recording From The Middle Of A Tape; Dual Rec; Auto/Manual Mode - JVC GR-D760EK Instructions Manual

Time Code

During recording, a time code is recorded on the
tape. This code is to confirm the location of the
recorded scene on the tape during playback.
Display
12 : 34 : 24
* Frames are not displayed during recording.
If recording starts from a blank portion, the time
code begins counting from "00:00:00"
(minute:second:frame). If recording starts from
the end of a previously recorded scene,
the time code continues from the last time code
number. If during recording a blank portion is left
partway through the tape, the time code is
interrupted. When recording is resumed, the
time code starts counting up again from
"00:00:00". This means the camcorder may
record the same time codes as those existing in
a previously recorded scene. To prevent this,
perform Recording From The Middle Of A Tape
pg. 21) in the following cases;
(
● When shooting again after playing back a
recorded tape.
● When power shuts off during shooting.
● When a tape is removed and re-inserted during
shooting.
● When shooting using a partially recorded tape.
● When shooting on a blank portion located partway
through the tape.
● When shooting again after shooting a scene then
opening/closing the cassette holder cover.
NOTES:
● The time code cannot be reset.
● During fast-forwarding and rewinding, the time
code indication does not move smoothly.
● The time code is displayed only when "TIME
CODE" is set to "ON". (

Recording From The Middle Of A Tape

1) Play back a tape or use Blank Search
( pg. 23) to find the spot at which you want to
start recording, then engage the Still Playback
mode. ( pg. 22)
2) Set the Power Switch to "REC" while pressing
down the Lock Button located on the switch,
then start recording.
Minutes
Seconds
Frames*
(25 frames = 1 second)
pg. 36)
VIDEO RECORDING

Dual Rec.

You can capture still images without disturbing
the recording in progress. Press SNAPSHOT.
A sub screen will be displayed for approx. 6
seconds to show you the
● The Still image is saved into the memory card
while video is recorded onto the cassette tape.
● "REC SELECT" must be set to "

Auto/Manual Mode

Press AUTO button repeatedly to switch to auto/
manual recording mode. When manual mode is
selected, the indicator "M" appears on the LCD
monitor.
Auto Mode: A
You can record using no special effects or
manual adjustments.
Manual Mode: M
Manual recording is possible by setting various
functions.
21
EN
snapshot image.
(CARD)".
M