Recording & Playback; Video Recording; Basic Recording; Tape Remaining Time - JVC GR-D760EK Instructions Manual

Basic Recording

NOTE:
Before continuing, perform the procedures listed
below:
● Power. (
pg. 14)
● Loading A Cassette. (
● Remove the lens cap. (
● Open the LCD monitor fully
● Select videos at 4:3 size or 16:9 (Wide) size.
( pg. 18)
VIDEO/MEMORY
1
Set the VIDEO/MEMORY Switch to "VIDEO".
2
Set the Power Switch to "REC" while pressing
down the Lock Button located on the switch.
3
Press START/STOP button to start recording.
"REC" appears on the display while recording is
in progress. To stop recording press
START/STOP again.
Approximate recording time
Tape
30 min. 30 min.
60 min. 60 min.
80 min. 80 min.
NOTES:
● If the Record-Standby mode continues for 5
minutes and no operation is performed, the
camcorder's power shuts off automatically. To turn
the camcorder on again, push back and pull out
the viewfinder again or close and re-open the LCD
monitor.
pg. 17)
pg. 13)
.
Zoom Lever
Lock Button
Recording Start/Stop
Button
Recording mode
SP LP
45 min.
90 min.
120 min.

VIDEO RECORDING

● When a blank portion is left between recorded
scenes on the tape, the time code is interrupted
and errors may occur when editing the tape. To
avoid this, refer to "Recording From The Middle Of
A Tape" ( pg. 21).
● To record in LP (Long Play) mode. (

Tape Remaining Time

Approximate tape remaining
time appears on the display.
"---min" means the
camcorder is calculating the
remaining time. When the
remaining time reaches 2 minutes, the indication
starts blinking.
● The time required to calculate and display the
remaining tape length, and the accuracy of the
calculation, may vary according to the type of tape
used.

Quick Review

Enables to check the end of the
last recording.
1) Press QUICK REVIEW during
the Recording-Standby mode.
2) Tape is rewound for about
several seconds and played back automatically,
then pauses in the Recording-Standby mode for
the next shot.
● Distortion may occur at start of playback. This
is normal.
● Slide the Power Zoom lever repeatedly to
change the sound setting to on/off.
19
EN
pg. 35)
62 min
CONTINUED ON NEXT PAGE