Playback Using The Remote Control - JVC GR-D760EK Instructions Manual

VIDEO PLAYBACK
24
EN
1
Make sure all units are turned off.
2
Connect the camcorder to a TV or VCR as
shown in the illustration.
If using a VCR, go to step 3.
If not, go to step 4.
3
Connect the VCR output to the TV input,
referring to your VCR's instruction manual.
4
Turn on the camcorder, the VCR and the TV.
5
Set the VCR to its AUX input mode, and set
the TV to its VIDEO mode.
6
Start playback on the camcorder. (
● Please set "16:9 OUTPUT" of Playback Menus so
that the image may suit your TV
(16:9 TV or 4:3 TV). (
To choose whether or not the following
displays appear on the connected TV
● Date/Time
Set "DATE/TIME" to "ON" or "OFF". (
Or, press DISPLAY on the remote control to turn
on/off the date indication.
● Time Code
Set "TIME CODE" to "ON" or "OFF". (
● Indications other than date/time and time code
Set "ON SCREEN" to "OFF", "LCD" or "LCD/TV".
( pg. 33)
NOTES:
● It is recommended to use the AC Adapter as
the power supply instead of the battery pack.
( pg. 15)
● To monitor the picture and sound from the
camcorder without inserting a tape or memory
card, set the camcorder's Power Switch to
then set your TV to the appropriate input mode.
● Make sure you adjust the TV sound volume to its
minimum level to avoid a sudden burst of sound
when the camcorder is turned on.
pg. 22)
pg. 18, 33, 36, 37)
pg. 33)
pg. 33)
"REC"
Playback Using The Remote
Control
A battery is included inside the remote control at
the time of purchase.
Remove the insulation sheet before use.
Installing The Battery
The remote control uses one lithium battery
(CR2025).
Pull out the battery
holder by pressing the
lock tab.
Beam Effective Area (indoor use)
When using the remote
control, be sure to point it at
the remote sensor. The
transmitted beam's
approximate effective
distance for indoor use is
5 m.
NOTE:
,
The transmitted beam may not be effective or may
cause incorrect operation when the remote sensor
is directly exposed to sunlight or powerful lighting.
Lock tab
Remote sensor