Audio Dubbing - JVC GR-D760EK Instructions Manual

[A] Using USB cable
It is possible to transfer still images stored on a
memory card to a PC.
[B] Using DV cable
It is also possible to transfer still/moving images
to a PC with a DV connector by using the
provided software, software equipped with the
PC or commercially available software.
If you are using a Windows
®
Windows Messenger to conduct video
conferences over the Internet, using a
camcorder. For details, refer to the help for the
®
Windows Messenger.
NOTES:
● Refer to "SOFTWARE INSTALLATION AND USB
CONNECTION GUIDE" for the bundled software
and drivers.
● It is recommended to use the AC Adapter as
the power supply instead of the battery pack.
( pg. 15)
● Never connect the USB cable and the DV
cable simultaneously to the camcorder.
Connect only the cable you wish to use to the
camcorder.
● When using a DV cable, be sure to use the
optional JVC VC-VDV206U or VC-VDV204U DV
cable depending on the type of DV connector
(4 or 6 pins) on the PC.
● If the PC connected to the camcorder via the USB
cable is not powered, the camcorder does not
enter the USB mode.
● The date/time information cannot be captured into
the PC.
● Refer to the instruction manuals of the PC and
Software.
● The still images can also be transferred to a PC
with a DV connector-equipped capture board.
● The system may not work properly depending on
the PC or capture board you are using.
● If, after connecting a DV cable to the camcorder
and it doesn't work, restart the camcorder.
● Do not remove memory card during USB
connection between PC and set.
"
"USB" and/or
LCD monitor while the PC is accessing data in
the camcorder or the camcorder is
transferring a file to the PC.
NEVER disconnect the USB cable while
" " is displayed on the LCD
monitor since this can result in product
damage.
®
XP, you can use
"
appears on the

Audio Dubbing

The audio track can be customised only when
recorded in the 12-BIT and SP modes.
( pg. 35)
● Use the provided remote control.
1
Play back the tape to locate the point where
editing will start, then press PAUSE (9).
2
While holding A. DUB (D) on the remote
control, press PAUSE (9). The "9D" indicator
appears.
3
Press PLAY (U), then begin "narrating".
Speak into the microphone.
● To pause dubbing, press PAUSE (9).
4
To end Audio Dubbing, press PAUSE (9),
then STOP (8).
To hear the dubbed sound during playback
Set "NARRATION" to "ON" or "MIX". (
NOTES:
● Sound is not heard from the speaker during Audio
Dubbing.
● When editing onto a tape that was recorded at
12-BIT, the old and new soundtracks are recorded
separately.
● If you dub onto a blank space on the tape, the
sound may be disrupted. Make sure you only edit
recorded areas.
● If feedback or howling occurs during TV playback,
move the camcorder's microphone away from the
TV, or turn down the TV's volume.
EDITING
EN
Speaker
Stereo
Microphone
pg. 37)
45