Multi - Vermona DRM1 MKIII User Manual

MULTI

MULTI contains three oscillators with broad tuning ranges. Because of this, the resulting sounds
are very flexible, ranging from bass drums and toms to cowbells and other metallic percussions to
sound effects.
sets the sound's length.
DECAY
defines the overall pitch/frequencies of all three oscillators.
PITCH
adjusts the amount of the DECAY envelope modulating PITCH. Turn clockwise from
BEND
the center position to modulate the pitch, descending it. Turn counterclockwise
from the center position will invert the modulation, resulting in ascending pitches.
adds a short fixed needle impulse to the sound's start to support its assertiveness.
ATTACK
Always adjust ATTACK in correlation to the complete mix.
sets the pitch/frequency of the second oscillator. Changing PITCH will always change
PITCH 2
the frequency of PITCH 2, too. PITCH 2 can be freely adjusted, so that it sounds
higher or lower than the first oscillator. With PITCH 2 set fully counterclockwise,
the second oscillator is turned off.
sets the pitch/frequency of the third oscillator. It works the same way than PITCH
PITCH 3
2 with the second oscillator.
adjusts the cutoff frequency of an additional high pass filter. It allows attenuating
HIGH PASS
bass frequencies of the sound if needed. The filter's effect depends upon the sound's
pitch. With PITCH/2/3 being adjusted above the 9 o' clock position, the high pass
filter's effect will be almost insignificant.
User Guide DRM1 MKIII
Figure 5: MULTI instrument channel of the DRM1 MKIII
EN
13