Table of Contents
Advertisement
Figure 49
1. Fuse block
Figure 50
Drive System
Maintenance
Adjusting the Traction Drive
for Neutral
If the machine moves when the traction pedal is in the
neutral position, the traction cam must be adjusted.
1. Park the machine on a level surface and turn the
engine off.
2. Raise one front wheel off of the floor and place
support blocks under the frame.
If the machine is not supported adequately, it
may accidentally fall, injuring anyone under
the machine.
3. Loosen the locknut on the traction adjustment cam
(Figure 51).
1. Traction adjustment cam
G009906
The engine must be running so a final
adjustment of the traction adjustment cam can
be performed. Contact with hot or moving parts
can result in personal injury.
Keep hands, feet, face, and other body parts
away from the muffler, other hot parts of the
engine, and other rotating parts.
4. Start the engine and rotate the cam hex in both
directions to determine the mid position of the
neutral span.
5. Tighten the locknut securing the adjustment.
6. Stop the engine.
44
Figure 51
Advertisement
Table of Contents
