Table of Contents
Advertisement
2
1
3
Figure 47
1. Fuel filter/water separator
canister
2. Vent plug
3. Close and tighten the drain valve.
Replacing the Fuel Filter
Canister
Service Interval: Every 400 hours
1. Place a clean container under the fuel filter and clean
area where the filter canister mounts.
2. Remove filter canister and clean the mounting
surface (Figure 47).
3. Lubricate gasket on filter canister with clean oil.
4. Install the filter canister by hand until the gasket
contacts mounting surface, then rotate it an
additional 1/2 turn.
Bleeding Air from the Fuel
Injectors
Note: This procedure should be used only if the
fuel system has been purged of air through normal
priming procedures and the engine will not start; refer
to Bleeding the Fuel System.
1. Loosen the pipe connection to one of the fuel
injectors (Figure 48).
G009880
3. Drain valve
1. Fuel injectors
2. Slowly move the throttle to the full Fast position.
3. Turn the key in the key switch to the Start position
and watch the fuel flow around the connector. When
you observe a solid flow of fuel, turn the key to the
Off position.
4. Tighten the pipe connector securely.
5. Repeat steps 1 through 4 on the remaining nozzles.
42
Figure 48
Advertisement
Table of Contents
