Table of Contents
Advertisement
Description
Operator's Manual
Engine Operator's Manual
Operator training material
Parts Catalog
Certificate of compliance
Note: Determine the left and right sides of the machine
from the normal operating position.
1
Installing the Rear Wheel
Parts needed for this procedure:
1
Wheel assembly
4
Lug nut
Procedure
1. Mount the wheel assembly onto the rear wheel hub
(Figure 2).
2
1. Wheel assembly
2. Rear wheel hub
2. Install the lug nuts (Figure 2) and tighten them to 45
to 65 ft-lb (3 to 5 N-m).
1
3
G009850
Figure 2
3. Lug nut
Qty.
1
Read before operating the machine.
1
1
View before operating the machine.
1
View and order parts.
1
CE certification
2
Adjusting the Rear Carrier
Frame Height
Parts needed for this procedure:
1
Rear carrier frame
Procedure
1. Slide the rear carrier frame onto the rear lift arm
pivot rod (Figure 3). Do not install the carrier frame
to the cutting unit at this time.
2
4
1. Rear carrier frame
2. Pivot rod
2. Raise the lift arms and carrier frame fully.
3. Press down on one end of the carrier frame until the
up stop on the opposite end contacts the underside
of the foot step (Figure 3).
The distance between the up stop and the underside
of the foot step, on the end pressed down, should be
approximately 1/4 inch (6 mm).
13
Use
3
1
3
G009851
Figure 3
3. Up stop
4. Lift cylinder
Advertisement
Table of Contents
