Fuel System Maintenance; Checking The Fuel Lines And Connections; Draining Water From The Water Separator - Toro 03431 Operator's Manual

Traction unit
Table of Contents

Advertisement

Figure 46
1. Oil filter
5. Apply a light coat of clean oil to the new filter seal.
6. Install the replacement oil filter to the filter adapter.
Turn the oil filter clockwise until the rubber gasket
contacts the filter adapter, then tighten the filter an
additional 1/2 to 2/3 turn.
Important: Do not over-tighten the filter.
7. Add oil to the crankcase; refer to Checking the
Engine Oil.
Fuel System
Maintenance
Under certain conditions, diesel fuel and fuel
vapors are highly flammable and explosive. A
fire or explosion from fuel can burn you and
others and can cause property damage.
• Use a funnel and fill the fuel tank outdoors,
in an open area, when the engine is off and
is cold. Wipe up any fuel that spills.
• Do not fill the fuel tank completely full. Add
fuel to the fuel tank until the level is 1/4 to
1/2 inch (6 to 13 mm) below the bottom of
the filler neck. This empty space in the tank
allows the fuel to expand.
• Never smoke when handling fuel, and stay
away from an open flame or where fuel
fumes may be ignited by a spark.
• Store fuel in a clean, safety-approved
container and keep the cap in place.
Checking the Fuel Lines and
Connections
Service Interval: Every 400 hours—Check the fuel lines
and connections for deterioration,
damage, or loose connections.
Draining Water from the Water
Separator
Service Interval: Before each use or daily
1. Locate the fuel filter and place a clean container
under it.
2. Loosen drain valve on bottom of filter canister and
allow the contents to drain (Figure 47).
41

Advertisement

Table of Contents
loading

This manual is also suitable for:

Reelmaster 2000

Table of Contents