Lubrication; Greasing The Bearings And Bushings - Toro 30446 Operator's Manual

Lubrication

Greasing the Bearings and
Bushings
The machine has grease fittings that must be lubricated
regularly with No. 2 General Purpose Lithium Base
Grease. If the machine is operated under normal
conditions, lubricate all bearings and bushings after
every 50 hours of operation or immediately after every
washing.
The grease fitting locations and quantities are:
Traction Unit
Service Interval: Every 50 hours
• Brake shaft pivot bearings (5) (Figure 36)
• Traction pedal pivot bushing (1) (Figure 37)
• Front and rear axle pivot bushings (2) (Figure 38)
• Steering cylinder ball joints (2) (Figure 39)
• Tie rod ball joints (2) (Figure 39)
• King pin bushings (2) (Figure 39).
The top fitting on the king pin should
only be lubricated annually (2 pumps).
Figure 36
35
Figure 37
Figure 38
Figure 39