Replacing The Drive Belts; Replacing The Headlight Bulb - Toro 38651 Operator's Manual

Figure 55
1. Cable conduit
3. Grasp the cable conduit and move it toward the front
of the machine until the discharge chute latch fully
engages the gear teeth (Figure 55 and Figure 56).
Figure 56
1. Discharge chute latch
Note: The latch is spring loaded and will naturally
move into the teeth of the gear (Figure 56).
4. Remove any slack in the cable by pulling the cable
conduit rearward.
5. Tighten the bolt on the cable clamp.
6. Install and secure the gear cover.

Replacing the Drive Belts

If the auger/impeller drive belt or the traction drive belt
becomes worn, oil-soaked, or otherwise damaged, go
to www.Toro.com for additional service information or
have an Authorized Service Dealer replace the belt.

Replacing the Headlight Bulb

Use a GE 892 16W halogen light bulb. Do not touch
the bulb with your hands or allow dirt or moisture to
come into contact with the bulb.
1. Remove the wire connector from the back of the
headlight (Figure 57).
2. Cable clamp
2. Gear teeth
2. Turn the base of the bulb counterclockwise until it
stops (Figure 58).
3. Remove the bulb straight out from the back of the
headlight (Figure 59).
4. Insert a new bulb into the back of the headlight
(Figure 60).
5. Turn the base of the bulb clockwise until it is snug
(Figure 61).
23
Figure 57
Figure 58
Figure 59
Figure 60