Table of Contents
Advertisement
Figure 48
1. Jam nut
6. Loosen or tighten the turnbuckle that adjusts the
tension on the cable (Figure 48).
7. Adjust the turnbuckle until you obtain the proper
gap.
8. Tighten the jam nut.
9. Insert the 2 screws you previously removed on the
belt cover.
10. If the auger/impeller cable is properly adjusted but
a problem remains, contact an Authorized Service
Dealer.
Checking the Auger Gearbox
Oil Level
Service Interval: Yearly—Check the auger gearbox oil
and add oil if necessary.
1. Move the snowthrower to a level surface.
2. Clean the area around the pipe plug (Figure 49).
Figure 49
3. Remove the pipe plug from the gearbox.
4. Check the oil level in the gearbox. The oil should be
at the point of overflowing at the filler opening.
2. Turnbuckle
5. If the oil level is low, add GL-5 or GL-6, SAE 85-95
EP transmission oil to the gearbox until the point
of overflow.
Note: Do not use synthetic oil.
6. Install the pipe plug in the gearbox.
Changing the Engine Oil
Service Interval: After the first 2 hours
Yearly
If possible, run the engine just before changing the
oil because warm oil flows better and carries more
contaminants.
Max. fill: 26 oz. (0.77 l), type: automotive detergent
oil with an API service classification of SF, SG, SH, SJ,
SL, or higher.
• For temperatures above 32°F (0°C), use SAE 30W.
• For temperatures between 0°F and 32°F (-18°C to
0°C), use SAE 5W30 or SAE 10W.
• For air temperatures below 0°F (-18°C), use
SAE 0W30.
1. Clean the area around the oil drain cap (Figure 50).
1. Oil drain cap
2. Slide an oil drain pan under the drain extension and
remove the oil drain cap.
3. Drain the oil.
Note: Dispose of the used oil properly at a local
recycling center.
4. Install the oil drain cap.
5. Fill the crankcase with oil. Refer to Filling the
Engine Crankcase with Oil.
Lubricating the Hex Shaft
Service Interval: Yearly
Lightly lubricate the hex shaft yearly with automotive
engine oil (Figure 51).
21
Figure 50
Advertisement
Table of Contents
