Table of Contents
Advertisement
OFA Kam 6 Hybrid Owners Manual.fm Page 16 Wednesday, March 30, 2005 3:09 PM
OFA Kameleon™ 6-Device Hybrid Remote
R
K
K
ESTORING
EYMOVED
EYS
S
ETTING
Restoring A Single Keymoved Key
1.
Press a device (e.g. VCR/PVR) key that
has a keymoved key.
2.
Press and hold SET until the two Inner
IR segments flash twice. The current
mode key will blink on and off during
programming.
3.
Enter 9 9 4. The Inner IR Segments will
blink twice.
4.
Press the destination key twice (where
the keymoved key is stored). The Inner
IR Segments will blink twice.
Restoring All Keymoved Keys In A Single
Mode
1.
Press and hold SET until the two Inner
IR segments flash twice. The current
mode key will blink on and off during
programming.
2.
Enter 9 9 4. The Inner IR Segments will
blink twice.
3.
Press the destination mode twice
(where keymoved keys are stored). The
Inner IR segments flash twice.
CHANGING VOLUME LOCK
The OFA Kameleon™ 6-Device Hybrid
Remote (URC-6690) is set at the factory for
independent volume control of each selected
device. However, you may change the
Volume Lock setting to Global Volume Lock
so that a device's volume will be locked to
one mode (e.g., to control TV volume in all
other modes). After that, if desired, you can
perform Individual Volume Unlock on a
selected device to set its volume control for
independent operation.
16 Changing Volume Lock
T
D
L
V
O
EFAULT
OCKING
OLUME
(G
V
LOBAL
OLUME
Press and hold SET until the two Inner
1.
IR segments flash twice. The current
mode key will blink on and off during
programming.
Enter 9 9 3 and then press any mode
2.
key once (e.g., TV). The Inner IR
Segments will blink twice.
Now, when you press VOL+, VOL-, or MUTE,
the volume of the selected device (e.g., TV)
will be controlled regardless of the mode you
have selected.
U
NLOCKING
S
D
INGLE
EVICE
U
):
NLOCK
1.
Press a desired mode key where you
want volume to be unlocked (e.g., AUD)
and controlled within its own mode.
2.
Press and hold SET until the two Inner
IR segments flash twice. The current
mode key will blink on and off during
programming.
3.
Enter 9 9 3 and then press VOL- once.
The Inner IR Segments will blink four
times.
4.
If desired, repeat steps 1 through 3 (of
this section) for each device that you
want volume to be unlocked.
Now, after you select a device that has
volume unlocked (e.g., AUD), pressing VOL+,
VOL-, or MUTE, will control the device's
volume only in its own mode.
U
NLOCKING
(R
ESTORING
NOTE: Performing these instructions will
restore independent volume control for all
programmed devices (e.g., TV volume
C
T
O
M
ONTROL
O
NE
ODE
L
):
OCK
V
C
F
A
OLUME
ONTROL
OR
(I
V
NDIVIDUAL
OLUME
A
V
C
LL
OLUME
ONTROL
D
S
):
EFAULT
ETTING
Hide quick links:
Advertisement
Table of Contents
