One for All OFA Kameleon URC-6690 User Manual page 22

OFA Kam 6 Hybrid Owners Manual.fm Page 20 Wednesday, March 30, 2005 3:09 PM
OFA Kameleon™ 6-Device Hybrid Remote
PROBLEM: No display when
programming.
SOLUTION: Display has turned off due to
inactivity. Start programming
again and do not pause while
performing instructions.
PROBLEM: During programming, the two
inner IR segments display a
long flash.
SOLUTION: An invalid entry has occurred.
Check the keys to be pressed
and start programming again.
PROBLEM: IR sent animation is displayed
when you press a key, but
home entertainment device
does not respond.
SOLUTION: Make sure the remote control
is aimed at your home
entertainment device and is
not farther than15 feet away.
PROBLEM: The unit does not control
home entertainment devices
or commands are not working
properly.
SOLUTION: Try all listed codes for the
device brands being set up.
Make sure they can be
operated with an infrared
remote control.
PROBLEM: Tried Searching For Your Code
method and still could not
find a working code.
SOLUTION: Perform Restoring Factory
Default Settings on page 17.
Then repeat Searching For
Your Code on page 10.
PROBLEM: Cannot program a macro onto
M1, POWER or other keys.
20 Troubleshooting
SOLUTION: Make sure the total number of
key presses being
programmed is less than 15
and that you are not trying to
program a macro on an
invalid key (Device keys, Set
Key and Fav key).
PROBLEM: Power macro does not execute.
SOLUTION: Make sure to press and hold
the POWER for at least three
seconds to initiate Power
Macro.
PROBLEM: Changing channels does not
work properly.
SOLUTION: If original remote control
required pressing ENTER or OK
to change channels, press
ENTER or OK on the remote
control after entering the
channel number.
PROBLEM: During learning, Inner IR
Segments display a long blink
after pressing and holding key
to be learned.
SOLUTION: Memory is full or a bad
capture has occurred. Avoid
high-ambient light sources,
such as direct daylight and
fluorescent bulbs. Try
readjusting positions of
remote controls before
performing the procedure
again.
PROBLEM: Tried Search For Your Code
method and still could not
find a working code.