Removing The Seat; Mounting The Seat; Removing The Air Filter Box Lid; Installing The Air Filter Box Lid - KTM 500 EXC Owner's Manual

11 SERVICE WORK ON THE CHASSIS
11.20

Removing the seat

11.21

Mounting the seat

11.22

Removing the air filter box lid

11.23

Installing the air filter box lid

11.24

Removing the air filter

Note
Engine failure Unfiltered intake air has a negative effect on the service life of the engine.
–
Never ride the vehicle without an air filter since dust and dirt can get into the engine and result in increased wear.
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
–
Remove screw
–
Lift up the seat at the rear, pull it back and then remove it from above.
101346-10
–
Hook in the front of the seat at the collar sleeve of the fuel tank, lower it at the rear
and simultaneously push it forward.
–
Make sure that the seat is correctly locked in.
–
Mount and tighten the screw of the seat fixing.
Guideline
Remaining screws, chassis
S00033-10
–
Pull off the air filter box lid in area
S00031-10
–
Insert the air filter box lid into the rear area
S00031-11
x
Preparatory work
–
Remove the air filter box lid. (
.
1
to the side and remove to the front.
A
p. 53)
M6 10 Nm (7.4 lbf ft)
and clip it into the front area
A
53
.
B