Specifications; General Power Tool Safety Warnings; Save All Warnings And Instructions For Future Reference - Makita GA7050 Instruction Manual

ENGLISH (Original instructions)
1. Shaft lock
2. Switch trigger
3. Lock lever
4. Indication lamp
5. Wheel guard
6. Screw
7. Bearing box
8. Nut
9. Lever
10. Lock nut
11. Depressed center wheel
12. Inner flange
13. Super flange

SPECIFICATIONS

Model
Depressed center wheel
diameter
Max. wheel thickness
Spindle thread
No load speed (n
0
Rated speed (n)
Overall length
Net weight
Safety class
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
...... Read instruction manual.
................ DOUBLE INSULATION
...... Wear safety glasses.
Intended use
The tool is intended for grinding, sanding and cutting of
metal and stone materials without the use of water.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
For model GA7050, GA9050
For public low-voltage distribution systems of
between 220 V and 250 V.
Switching operations of electric apparatus cause voltage
fluctuations. The operation of this device under
Explanation of general view
14. Lock nut wrench
15. Abrasive disc
16. Rubber pad
17. Ezynut
18. Abrasive wheel/Multi-disc
19. Spindle
20. Arrow
21. Notch
22. Wire cup brush
23. Wire wheel brush
24. Abrasive cut-off wheel/diamond
wheel
GA7050
180 mm
6.5 mm
M14
)/
-1
8,500 (min
432 mm
4.5 kg
GA7050R
180 mm
6.5 mm
M14
-1
) 8,500 (min )
455 mm
4.6 kg
END202-8
unfavorable mains conditions can have adverse effects to
the operation of other equipment. With a mains
impedance equal or less than 0.22 Ohms it can be
presumed that there will be no negative effects. The
mains socket used for this device must be protected with
a fuse or protective circuit breaker having slow tripping
characteristics.
General Power Tool Safety
Warnings
WARNING Read all safety warnings and all
instructions. Failure to follow the warnings and
ENE048-1
instructions may result in electric shock, fire and/or
serious injury.
ENF002-2
Save all warnings and
instructions for future reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-operated
(cordless) power tool.
ENF100-1
Work area safety
1. Keep work area clean and well lit. Cluttered or dark
areas invite accidents.
25. Wheel guard for abrasive cut-off
wheel/diamond wheel
26. Outer flange 78
27. Inner flange 78
28. Exhaust vent
29. Inhalation vent
30. Commutator
31. Insulating tip
32. Carbon brush
33. Brush holder cap
34. Screwdriver
GA9050
230 mm
6.5 mm
M14
-1
6,600(min )
432 mm
4.7 kg
/II
GA9050R
230 mm
6.5 mm
M14
-1
6,600 (min )
455 mm
4.8 kg
GEA005-3
5