Sony PMW-EX30 Operating Instructions Manual page 46

Video signal to
record
HDV signals input to
the HDV/DV
connector
HDSDI signals input
to the HD SDI
INPUT connector
Internal test signal
(100% full color bar)
Internal test signal
(100% full color bar)
Note
It is not possible to change the input
signal during recording. If the VIDEO
INPUT switch position is changed, the
setting is not enabled until the
recording stops with the STOP button
pressed.
3
When recording audio signals input to
the AUDIO INPUT CH-1 and CH-2
connectors, set the AUDIO INPUT
LEVEL switch as follows.
46 Recording
VIDEO INPUT
switch position
(input signal
indication on the
monitor screen)
i.LINK (i.LINK in)
HD SDI (HDSDI in)
SG (Internal SG)
SG (Internal SG)
Audio signal to
record
2-channel digital
audio signals
embedded in the
input HDV signals
Analog audio
signals input to the
AUDIO INPUT CH-1
and CH-2
connectors
Channels 1 and 2 of
digital audio signals
embedded in the
input HDSDI signals
Channels 3 and 4 of
digital audio signals
embedded in the
input HDSDI signals
1 kHz reference
audio signal
When audio signals output from an
XLR connector: +4 or –2
When audio signals output from a
phono jack: –10
The following table shows the relation
between the switch position and
maximum audio level available.
Position
–10
–2
+4
AUDIO INPUT
switch position
—
ANALOG
HD SDI CH-1/2
HD SDI CH-3/4
Regardless of the
AUDIO INPUT
switch position, set
"1KHz Tone" in the
"Audio Input" setting
of the AUDIO SET
menu to "On" (see
page 85).
Audio level
+10 dBu
+18 dBu
+24 dBu