Maintenance; Sound Pressure Level; Vibration Level - Toro 07277 Workman 2110 Operator's Manual

Maintenance

• Only qualified and authorized personnel shall be
permitted to maintain, repair, adjust, or inspect the
vehicle.
• Before servicing or making adjustments to the machine,
stop the engine, set the parking brake, and remove the
key from the ignition to prevent someone from
accidentally starting the engine.
• To make sure that the entire machine is in good
condition, keep all nuts, bolts, and screws properly
tightened.
• To reduce the potential for fire, keep the engine area
free of excessive grease, grass, leaves, and
accumulation of dirt.
• Never use an open flame to check the level or leakage
of fuel or battery electrolyte.
• If the engine must be running to perform a maintenance
adjustment, keep your hands, feet, clothing, and any
parts of your body away from the engine and any
moving parts. Keep everyone away.
• Do not use open pans of fuel or flammable cleaning
fluids for cleaning parts.
• Do not adjust the ground speed governor. To ensure
safety and accuracy, have an Authorized Toro
Distributor check the ground speed.
• If major repairs are ever needed or assistance is
required, contact an Authorized Toro Distributor.
• To be sure of optimum performance and safety, always
purchase genuine Toro replacement parts and
accessories. Replacement parts and accessories made by
other manufacturers could be dangerous. Altering this
vehicle in any manner that may affect vehicle operation,
performance, durability, or its use, may result in injury
or death. Such use could void the product warranty.

Sound Pressure Level

This unit has an equivalent continuous A-weighted sound
pressure level at the operator ear of 80 dBA based on
measurements of identical machines per Directive
98/37/EC and amendments

Vibration Level

This unit does not exceed a vibration level of 2.5 m/s
the hands based on measurements of identical machines per
ISO 5349 procedures.
This unit does not exceed a vibration level of 0.5 m/s
the posterior based on measurements of identical machines
per ISO 2631 procedures.
2
at
2
at
7