Checking The Transmission Oil; Operation; Think Safety First; Controls - Toro 07277 Workman 2110 Operator's Manual

Filling the Fuel Tank
Fuel tank capacity is approximately 7 gallons (26.5 l).
1. Shut the engine off and set the parking brake.
2. Clean the area around the fuel tank cap (Fig. 12).
Figure 12
1. Fuel tank cap
3. Remove the fuel tank cap.
4. Fill the tank to about one inch (25 mm) below the top of
the tank, (bottom of the filler neck). This space in the
tank allows gasoline to expand. Do not overfill.
5. Install the fuel tank cap securely. Wipe up any fuel that
may have spilled.

Checking the Transmission Oil

The transaxle fluid level should be at the bottom of the
level indicator hole (Fig. 13). If it is not, fill the reservoir
with the appropriate fluid; refer to Changing the Transaxle
Fluid, page 36, steps 3 and 4.
1
Figure 13
1. Level indicator hole

Operation

Note: Determine the left and right sides of the machine
from the normal operating position.

Think Safety First

Please carefully read all of the safety instructions and
decals in the safety section. Knowing this information
could help you or bystanders avoid injury.
1

Controls

Accelerator Pedal
The accelerator pedal (Fig. 14) gives the operator the
ability to vary ground speed of the vehicle. Depressing the
pedal starts the engine. Depressing the pedal farther
increases ground speed. Releasing the pedal will slow the
vehicle and the engine will stop running. Maximum
forward speed is 18 MPH (29 km/h).
Brake Pedal
The brake pedal is used to stop or slow the vehicle
(Fig. 14).
Brakes can become worn or can be misadjusted
resulting in personal injury.
If brake pedal travels to within 1 in. (25 mm) of
the vehicle floor board, the brakes must be
adjusted or repaired.
2
1
1. Accelerator pedal
m–4849
19
Caution
Figure 14
2. Brake pedal
m–5908