Fixture Linking (Master/Slave Mode); Mounting/Rigging - Blizzard Lighting ToughSTICK RGBAW Operating Instruction

Fixture Linking (Master/Slave Mode)

Check the "Operating Adjustments" section in this manual for
complete instructions for this type of setup and confi guration.
Mounting & Rigging
This fi xture may be mounted in any SAFE position provided there is
enough room for ventilation.
It is important never to obstruct the fan or vents pathway. Mount the
fi xture using a suitable "C" or "O" type clamp. The clamp should be
rated to hold at least 10x the fi xture's weight to ensure structural
stability. Do not mount to surfaces with unknown strength, and ensure
properly "rated" rigging is used when mounting fi xutres overhead.
Adjust the angle of the fi xture by loosening both knobs and tilting the
fi xture. After fi nding the desired position, retighten both knobs.
• When selecting installation location, take into consideration lamp
replacement access (if applicable) and routine maintenance.
• Safety cables MUST ALWAYS be used.
ToughSTICK™ RGBAW Manual - Rev. B
1. Connect the (male) 3 pin connector side of the
DMX cable to the output (female) 3 pin connector of
the fi rst fi xture.
2. Connect the end of the cable coming from
the fi rst fi xture which will have a (female) 3 pin
connector to the input connector of the next fi xture
consisting of a (male) 3 pin connector. Then,
proceed to connect from the output as stated above
to the input of the following fi xture and so on.
Page 9
A quick note: Often,
the setup for Master-
Slave and Standalone
operation requires that
the fi rst fi xture in the
chain be initialized for
this purpose via either
settings in the control
panel or DIP-switches.
Secondarily, the fi xtures
that follow may also
require a slave setting.
Copyright (c) 2012 Blizzard Lighting, LLC