Tint/Phase Adjustment; Adjustment Of Horizontal Display Start Position And Pixel - Kenwood DDX7019 Service Manual

3. TINT/PHASE adjustment

● Adjustment requirement. The adjustment is
required to the model for PAL regions (other
than K and R)
Input signal:Input magenta (PAL) in VIDEO1.
● Adjustment method
q Press Auto Adjust on the Test Mode Main screen.
w Press Tint/Phase on the Auto Adjust screen.
e After the automatic adjustment, complete the adjustment
by confirming that "Auto Set OK" is displayed and that
no flickering or horizontal stripes are observed on the
magenta.
DDX7019/7029/7029Y/7039/8019/8029/8029Y/8039
DNX7100/710EX/7200
ADJUSTMENT
4. Adjustment of Horizontal display start
position and Pixel
• GRAPHIC Adjustment screen
Horizontal
screen position
adjustment OSD
Screen Position Adjustment key (HPOSI): Adjustment of
horizontal display starting position of the entire screen
(Default: 0)
Display Range Adjustment key (DOT_FREQ): Adjustment of
horizontal display range of the video (Default: 64)
Pixel Adjustment key (DOT_PHASE): Adjustment of
horizontal display position of pixel (Default: 15)
Video on the Adjustment screen
GRAPHIC: Special screen used only for adjustment (See
below)
DNX_NAVI: Special screen used only for adjustment of
DDX_NAVI: Input KNA-DV3200 or KNA-G520.
* Adjustment screen changes as the connected NAVI.
Screen Position Adjustment key
Proceed to the next
adjustment screen
Pixel Adjustment key
Return to the Menu screen
Display Range Adjustment key
GARMIN (See below)
Horizontal
screen position
adjustment OSD
9