Operation Of Remote Control - Lanzar VBD2400U Instruction Manual

Hide thumbs

Table Of Contents

Table of Contents

Enlarged version

20. LOC/DX BUTTON

Radio station search mode is divided by this LOC/DX switch, this button can

be used to control an attenuator in the tuner during search. The detecting level

of seek, scan, auto-memory will be reduced as much as the attenuated level

of the tuner. In radio mode, press the LOC button to change local reception or

distance reception. Note: This button is only for FM reception. In AM mode,

LOC is void.

21. SCAN Button

Press the SCN button to scan the radio frequency. If a valid signal has detected,

the current frequency will be hold and blinked for 5 seconds, then press SCN

again to stop scan and remain the current frequency; otherwise, the radio will

go on to scan the other radio frequency five seconds later.

22. CLOCK BUTTON

Press the CLK button briefly to display time for 5 seconds on the display, and

then returns to its previous display unless the button is pressed again.

Then press the CLK button and hold for more than 1 seconds until the real time

flashes on the display. Then you can adjust HOUR or MINUTE by rotating the

VOL knob.

23. EJECT KEY

In the power on state, the loaded disc can be ejected by pressing the EJ key.

24. CD SLOT

25. USB SOCKET

When needing to play the file in the USB bar, turn over the plastic cover cap

then insert the USB bar into the USB socket. The system will change into the

USB mode automatically, and then play the first file in the USB.

When no needing to do USB operation, please cover the plastic cover cap.

26. MMC/SD CARD SOCKET

When you need to play the file in the MMC/SD card, insert the MMC/SD card

into the MMC/SD card socket. The system will change into the MMC/SD mode

automatically, and then play the first file in the MMC/SD.

Note:

When MMC/SD card and USB bar are both inserted into their slot or socket,

the system will change into the playback mode of the latter one.

27. FLASHING LED

When the front control panel is removed this indicator flashes.

28. RESET BUTTON

Before operating the unit for the first time, or after replacing the car battery or

changing the connections. You must reset the unit.

Press this button with a cuspidal object. This operation will erase the clock

setting and some stored contents.

Page 7