Maintenance And Cleaning Of Discs; Battery Information Of Remote Control - Lanzar SD82 Instruction Manual

1.3 Maintenance and Cleaning of Discs

Disc Maintenance
1. To keep the disc clean, andle the disc by its edge, do not touch the disc h
surface of the play side.
2. Do not stick paper or tape on the disc. If there is glue (or analog) on the
disc surface, must wipe it up before using.
3. Do not expose the disc to direct sunlight, or nearby heat sources such as
caliduct, or leave it in a car parked in direct sunlight where there can be a
considerable rise in temperature.
4. Put the disc inside disc case to keep temperature after finishing playback.
Disc Cleaning
1. Before playing, wipe the disc with a clean lint. wipe the disc outwards from
the disc center.
2. Do not use petrel, thinner, commercially cleaner or anti-static spray used to
plastic LP to wipe disc.
Fig.1

1.4 Battery Information of Remote Control

Replace Battery in Remote Control
1.Before using the remote control for the first time, pull the insulating
sheet out of the remote control as the direction indicated by the
arrow.(see fig.1)
2.Press the movable block hold as the direction indicated by the A arrow
(See fig.2), then pull the battery holder out of the remote control as
the direction indicated by the B arrow(see fig.2).
3.Replace the old battery by a new battery with (+) polarity side upward.
(See fig.3).
4.Insert the battery holder to the original position in remote control.
(See fig.3).
Note about the Battery of Remote Control
1. Improper use of battery may cause overheating or explosion. so that
Result in injury or fire .
2.Battery leakage may cause damage to the remote control(Battery
Life: 6 months with normal use in normal room temperature).
3.Do not short the battery.
4.Do not throw the battery into the fire.
5.To avoid the risk of accident, keep the battery out of reach of children.
PDF created with FinePrint pdfFactory trial version
+ side up
B
A
Fig.2 Fig.3
:
:
http://www.pdffactory.com
6. Trouble Shooting
Symptom Cause
Power does not IR Remote not
turn on functioning.
DVD Disc does Another disc is
not insert. Already in unit.
The disc is ejected The disc has
as soon as it is been inserted
inserted. Upside down.
Sound skips or Disc is dirty.
noisy.
Disc is seriously
scratched or
warped.
Sound is bad Condensation may
after power is have formed on the
turned on. Internal lens when
The car is parked in
a humid place.
Solution
Check the IR remote
For a good battery.
Eject first DVD disc
And insert another
into unit.
Insert the disc with
the label side up.
Clean the disc with
A soft cloth.
Replace the disc
with no scratches.
Let dry for about
one hour with the
power turned on.