Auto Names And Stereo Linking - ALLEN & HEATH ME-1 User Manual

8.6 Auto Names and Stereo linking

Names
Channel names created at their source and
sent via the Cat5 cable can be detected and
used by the ME-1 mixer.
Source: 17-18
Name: Synth
Members:
Preset: StoreRecall
The ME-1 displays the received name in the
Key Setup screen. This is used as the
'Default' name. Alternatively, custom key
names can be created and stored in the ME-1
mixer.
Examples:
Bass - If a name is available from the source
then the ME-1 will display this as the Default.
IP5 or Aux2 – If a name has not been applied
or has been reset at the source then the ME-1
will display channel type and number.
Unused – If the channel has been
unassigned at the source then the ME-1 will
display this label.
5 – If the auto name is not available then the
channel number will be displayed instead.
Stereo Links
Odd/even channels may be linked as stereo
pairs at their source before being sent via the
Cat5 cable to the ME-1.
This lets you assign a stereo linked pair to
just one key. For stereo pairs, Pan becomes
a Balance control to adjust the relative left
and right signal levels.
Source: 17-18
Name: Synth
Members:
Preset: StoreRecall
User Guide – AP8997 iss.3
SyntL
SyntL
Only the odd (left) channel of a linked pair is
shown in the Key Assign and group Members
lists.
Stereo linked channel examples – Link
sources such as stereo keyboards, effects
returns, audience microphones.
Auto names and stereo linking are available
from:


dSNAKE port – Any available dSNAKE
or Expander port at the surface or rack,

AR2412 Monitor port – Operating in
either ME-1 (40 channel) or Aviom
channel) mode,

AB168 Expander port

I/O Port MMO card - Aviom
channels) [Stereo links only]

Port B ACE via ME-U hub – Using two
cables, one for ACE to the hub input (audio)
and the other connecting the Network (stereo
linking and names).

Port B ACE (without ME-U) - Stereo
linking and names are not available from iLive
when connected directly to ME-1 via ACE.

iLive Port B MMO card - Aviom
(16 channels). Aviom
links only].

Note If you are connecting ME-1 directly to
ACE and therefore have no network link, you
can clear any previously received stereo links
and names in the ME-1 using its Menu screen
System Setup / Reset Source List
Config:
Unit:
Mic Mute:
Reset Source List
Firmware: V1.11r1485
25
= Names / Links
® (16
® port (16
®
port
® mode only [Stereo
function.
MATT
MM4
ALLEN&HEATH