Rewinding The Trimmer Spool - Toro 53002 Operator's Manual

Scaling
To remove unwanted vegetation, hold the trimmer head
about 3 in. (7.6 cm) above the ground and at an angle.
Allow the tip of the line to strike the ground cutting the
vegetation off at the surface (Fig. 15).
Figure 15
Mowing
Keep the line parallel to the ground and use a gentle
side-to-side motion (Fig. 16).
Figure 16
13

Rewinding the Trimmer Spool

POTENTIAL HAZARD
Use of improper line could cause line to break
and be thrown in operator's or bystander's
direction.
WHAT CAN HAPPEN
Use of improper line could result in serious
personal injury.
HOW TO AVOID THE HAZARD
Use only good quality, commercial grade, weld
resistant trimmer line with a diameter of .095
inches (2.413 mm).
Do not use any type of wire or other string-like
substance. Do not use metal-reinforced line.
1. Push in on one side of the head where it says to "push
open" then pull on bottom (Figs. 17).
Figure 17
1. Push here
2. Remove the empty spool from the head (Fig. 18).
1