Starting And Stopping; Before Starting The Engine - Toro 53002 Operator's Manual

Fuel Mixture Chart
Gasoline
1 gallon
2 gallons
5 gallons
Mixing Instructions
IMPORTANT: Never mix gasoline and oil directly in
the String Trimmer fuel tank.
1. Always mix fuel and oil in a clean container approved
for gasoline.
2. Mark the container to identify it as fuel mix for the
String Trimmer.
3. Use regular unleaded gasoline and fill the container
with half the required amount of gasoline.
4. Pour the correct amount of oil into the container then
add the remaining amount of gasoline.
5. Close the container tightly and shake it momentarily to
evenly mix the oil and the gasoline before filling the
fuel tank on the String Trimmer.
6. When refilling the String Trimmer fuel tank, clean
around the fuel tank cap to prevent dirt and debris
from entering the tank during cap removal.
7. Always shake the premix fuel container momentarily
before filling the fuel tank
8. Always use a spout or funnel when fueling to reduce
fuel spillage.
9. Fill the tank only to within 1/4–1/2 inch (6mm–13mm)
from the top of the tank. Avoid filling to the top of the
tank filler neck.
9
50:1 2-cycle oil
2.6 oz.
5.2 oz.
12.8 oz.

Starting And Stopping

Before Starting The Engine

1. Fill the fuel tank as instructed in the Before Operation
section of this manual.
2. Rest the String Trimmer on the ground.
3. Make sure the trimmer head is clear of any broken
glass, nails, wire, rocks or other debris.
4. Keep all bystanders, children and animals away from
the working area.
Cold Starting Procedure
The carburetors on Toro engines contain a choke system.
To start a "cold" engine properly, perform the following
procedure:
1. Pump the primer bulb at the bottom of the carburetor
until fuel can be seen flowing through the fuel return
line to the fuel tank (Figs. 7 and 8). (Flowing fuel
should be almost clear, not foamy or full of bubbles.)
Figure 7
1. Primer Bulb 2. Fuel Return Line