Replacing Line; Removing The Spool; Rewinding The Spool; Installing The Spool - Toro 51347 - Outdoor 11'' Trim Operator's Manual

Replacing Line

For replacement line, you can purchase either a new,
pre-wound spool of line (model no. 88175, 88052, or
88035) or bulk line (0.065 inch dia. (1.6 mm) x 30 ft.
(9 m)) that you can wind onto the old spool. Both are
available from your Authorized Toro Dealer.
Caution
Metal wire, rope, plastic knives, or any material
other than Toro .065 inch dia. (1.6 mm) nylon
monofilament may overload the motor, possibly
causing a fire or electrical shock.
Do not use any material other than Toro .065 inch
dia. (1.6 mm) nylon monofilament, 30 ft. (9 m)
maximum line length.

Removing the Spool

1. Twist the cap off
counterclockwise.
2. Remove the cap
and spool.
Note: If the spring falls
off, install it before

installing the spool.

3. Thoroughly clean
the cutting head and cap
and inspect them for any
damaged or worn parts.

Rewinding the Spool

Note: If you are replacing the spool with a new,
pre-wound spool, discard the empty spool and skip
this section.
1. Remove any cutting line left on the spool.
2. Hook one end of line
all the way into the slot
on the spool, allowing
no more than 1/8 inch
(3 mm) to protrude.
3. Wind the line in the direction of the arrow on the
spool, in level rows, between the spool flanges.
Note: The trimmer will not function correctly if you
wind the line in the wrong direction, the end of the line
protrudes more than 1/8 inch (3 mm), or you wind
more than 30 ft of line on the spool.
m-6302
m–7855
3352-881
5
Installing the Spool
Caution
If you do not fully install the spool and cap, the
trimmer could throw them during operation,
causing injury to you or bystanders.
1. Holding the line and
spool, insert the spool
into the cutting head and
the line into the eyelet.
2. Holding the line and
spool, place the cap
over the spool.
3. Twist the cap on
securely clockwise.
m–7853
m–7854
m-6303