Table of Contents
Advertisement
Accessories
The following accessories may be purchased at your local
authorized TORO Service Dealer.
1. Single Strap Harness, Model No. 46–2951 and
Deluxe Strap Harness, Model No. 46–2961—safety
release straps made out of durable nylon webbing
(Fig. 37).
Figure 37
1. Red Band
2. Strap
Troubleshooting
Problem
Engine Will Not Start
Engine Will Not Idle
Engine Lacks Power or Stalls When
Cutting
Cutting
If further assistance is required, contact your local authorized Toro service dealer.
3. Ring
Cause
STOP switch set to off position
Empty fuel tank
Primer bulb wasn't pushed enough
Engine flooded
Idle speed set incorrectly
Throttle wire has come loose
Dirty air filter
POTENTIAL HAZARD
Without the Brushcutter blade shield installed
on the String Trimmer, the Brushcutter blade
can throw foreign objects.
Without the correct blade shield, handles and
strap installed on the String Trimmer, the
Brushcutter can produce side thrust which can
expose the operator and bystanders to blade
contact.
WHAT CAN HAPPEN
Contact with the Brushcutter blade or thrown
objects can cause severe personal injury.
HOW TO AVOID THE HAZARD
Never install only a Brushcutter blade onto a
String Trimmer.
To convert a String Trimmer to a Brushcutter,
you must purchase and install the entire
Brushcutter Accessory Kit.
2. Brushcutter Accessory Kit, Model No.
53050—allows you to convert the String Trimmer to a
Brushcutter; available for Industrial Models (53002
and 53003) only.
Move switch to on position
Fill fuel tank
Press primer bulb until fuel flows
through fuel return line
Use warm engine starting
procedure
Set idle speed
Tighten throttle wire
Clean or replace air filter
Action
22
Advertisement
Table of Contents
