Toro 53002 Operator's Manual page 15

1
Figure 18
1. Spool
3. Clean the dirt from the inside of the spool parts if
required.
4. Cut two (2) new lines (10'–15') of equal length.
5. Place ends of line in holes on inside of spool
(Figs. 19).
6. Place the two (2) lines through the slits and wind the
line in even, tight layers onto the spool in the direction
indicated on the spool (Figs. 19).
3
2
Figure 19
1. Holes
2. Slits
7. Snap the two (2) ends in the grooves as indicated,
leaving 3-4 inches of line to be placed through eyelets
(Figs. 20).
1
2
3
3. Wind direction arrow
1
1
Figure 20
1. Groves
8. Thread the two ends of the line through the eyelets,
place spool into head and pull line to release from
grooves (Figs. 21).
1
Figure 21
1. Eyelets
9. Align the eyelet projections andsnap the cover and
head together (Figs. 22).
1
14