C- Card Thickness Control Lever; D- Card Output Hopper - Javelin J320i User Manual

Quick Start
General
Information
Getting
Started
Operation
Starting to
Print Cards
Cleaning
Trouble
Shooting
Technical
Specifications
1 1

C- CARD THICKNESS CONTROL LEVER

This item is operated by the user to prevent more than one card feeding into
the printer at the same time and causing a jam.
Card thickness:
A - 60mil (1.524mm) to 50mil (1.27mm)
B - 40mil (1.016mm)
C - 30mil (0.762mm) - DEFAULT
D - 20mil (0.508mm)
E* - Less than 20mil (0.508mm)
* Start at lowest position and move lever up to
match card thickness.
For other card thickness, start lever at lowest
position and move up until cards feed.
D - CARD OUTPUT HOPPER
This item is used for collecting printed cards.
OPERATION
Open cover, and adjust lever to the
correct position for the card thickness you
are using. Repeat for different card thickness.
(Factory setting is for 30mil (0.762 mm) card
thickness). See diagram below :
Install card output hopper to printer by
hooking over bottom edge of card exit aperture.
Rev. 1.1