Settings During A Call; System - Konftel 300IP User Manual

seTTInGs

seTTInGs DURInG a call

The HEADSET/PA, PHONE BOOK, TRANSFER and EQUALIZER menus may be ac-
cessed during a call and are displayed when the MenU button is pressed. The first
option is either HEADSET or PA depending on whether PA is activated or not.
 These HEADSET/PA settings can only be accessed when a call is connected.
Turn off the internal speakers when using a headset
 PA should not be activated when using the HEADSET menu option.
A wireless headset can be used if a person needs to move far away from the conference
phone (e.g. during a seminar or presentation). The internal speakers can be turned
off temporarily if you wish to use the Konftel 300IP as a personal telephone with a
headset.
 Select MenU > HeaDseT.
 Select YES when asked "SPEAKER OFF?".
 The speakers come on automatically when the call is ended.
adjusting microphone volume from Pa
 PA should be activated when using the PA menu option.
 Select MenU > Pa > Pa MonIToR.
 Adjust the microphone volume from the mixer so that the level on the display screen
is around 10–12 when speaking in a normal tone.
adjusting Pa calibration manually
It is possible to calibrate the duplex performance of the conference phone when it is
connected to a PA system. The calibration level can be set automatically by the Konftel
300IP or adjusted manually to any value between 0 and 5 (0 being full duplex).
• Increase the calibration if the other party experiences disturbing echo.
• Decrease the calibration if the other party experiences low duplex, i.e. your voice is
muted or clipped when the other party is speaking.
 The position of the PA system's microphones and speakers and the amplifier's set-
tings may affect full duplex performance.
28
 Select MenU > Pa > calIbRaTIon.
 AUTO is the default setting and is recommended in most cases. The figure shown in
brackets is the measured calibration value.
 Select different levels and compare the audio quality to achieve your preferred setting.
 NB. You must ask the person you are calling to assess the effect of the adjustments
you make.

sYsTeM

The system menu can be used for manual restarts and resets.
Restarting the phone programme
This restarts the phone, which takes about two minutes.
 Select MenU > sYsTeM > ResTaRT (6,1).
 Confirm that you really want to restart by pressing oK again, or cancel the restart by
pressing c.
Restarting the phone
This restarts the telephone application, which takes less than 30 seconds.
 Select MenU > sYsTeM > RebooT (6,2).
 Confirm that you really want to restart by pressing oK again, or cancel the restart by
pressing c.
Restore to factory settings
This option fully restores the Konftel 300IP to factory settings. All settings are deleted,
including PIN codes and registered accounts. Alternatively, a PIN code is required for
Admin.
 Select MenU > sYsTeM > facToRY ReseT (6,3).
 Enter the PIN code for Admin and press oK.
 Confirm that you really want to restart by pressing oK again, or cancel the restart by
pressing c.
seTTInGs
29