Arctic Cat 450 i TRV/OT User Manual page 61

• R (reverse)/N (neutral)/H
range)/L (low range).
 NOTE: An E will be displayed if
there is an error caused by a no-
shift position signal.
7. Speedometer/Tachometer - A nee-
dle indicates approximate vehicle
speed in mph or km/h when speed-
ometer function is selected or rpm
when tachometer
selected.
8. Needle Indicator Display - Displays
which speedometer function (MPH
or km/h) or tachometer function
(RPM) is selected.
 NOTE: The speedometer and
tachometer functions
switched by pressing the Set/
Reset Button.
9. 4WD Lock Indicator - Displays
LOCK when the front differential
lock has been engaged.
10. Drive Select Indicator - Displays
4WD when selected by the drive
select switch or when the 4WD lock
is engaged. The display is blank
when in 2WD.
11. High Beam Indicator - The High
Beam icon will appear only when
the headlights are on high beam.
12. Battery Condition Indicator - The
(high
speedometer/tachometer needle will
not function and the LCD will go
blank except the word VOLT will
flash on the LCD whenever a low
voltage (< 9 DC volts) or high volt-
age (>16 DC volts) is detected. When
voltage returns to normal, the gauge
must be reset by turning the ignition
key to OFF; then back to ON.
function is
may be
13. Temperature Indicator - The speed-
ometer/tachometer
sweep full scale and the LCD will go
blank except the high temperature
icon will flash. After 30 seconds, the
speedometer/tachometer needle and
LCD will return to normal, but the
temperature icon will continue to
flash. The icon should not be visible
during normal operation.
CF101A
Continued
engine temperature may result in
engine damage or premature wear.
CF098A
needle
CF099A
CAUTION
operation with high
59
will