Arctic Cat 450 i TRV/OT User Manual page 30

Prevention
2. CONTROLS AND
CABLE
With the engine running and brake
applied, check all transmission posi-
tions: forward, neutral, and reverse.
Check:
1. Forward
2. Neutral
3. Reverse
A. Brakes
Squeeze your hand brake lever. If it feels
soft or "squishy," it could be low on fluid
or have a leak — refer to the General Main-
tenance section of this Operator's Manual
for instructions. Don't use the ATV until
the brakes are operating normally.
Check:
1. Hand brake lever
2. Rear foot brake
3. Brake lever lock
Test the brake lever lock and see if it locks
the hand brake lever into position; then
disengage it to release the brake. Be sure
the rear foot brake near the footrest is
working; your brakes could fail during a
ride if they're not maintained.
B. Throttle
The throttle should have a free, smooth
range of motion. If it seems to "stick" at
any point, refer to the General Mainte-
nance section of this Operator's Manual
for instructions. Driving your ATV with a
sticking throttle can turn your leisurely
ride into an unwelcome accident. Don't
drive your ATV if the throttle sticks.
Check:
1. Free, smooth range of motion
28
! WARNING
3. LIGHTS AND
ELECTRICAL
Turn the hi-beam and lo-beam on and off
to make sure they work. At the same
time, verify the taillight and brakelight
work. Also, check the status/warning
indicators (reverse, neutral, and HI-LO
beam) on the LCD when you start the
ATV. Don't drive the ATV unless all sys-
tems are working. Check the ignition
switch and engine stop switch.
Check:
1. Hi-beam
2. Lo-beam
3. Taillight/brakelight
4. Status/warning indicators
5. Ignition switch
6. Engine stop switch
4. OIL AND FUEL
Start with a full tank of gas before every
ride, and while you're at it, top off the oil.
Don't forget to check for fluid leaks around
the ATV. Watch the overheat lamp to
ensure the engine coolant level is adequate.
Check:
1. Gas
2. Oil
3. Fluid leaks
5. CHASSIS AND
DRIVE TRAIN
Grass and leaves can gum-up your sus-
pension and shocks. Clear and clean the
suspension arms, shock springs, and
fenders. Check smoothness by turning
the handlebar full-left and full-right. Ver-
ify there is no binding, restrictions, free-
play, or looseness in steering compo-
nents.
Check:
1. Suspension arms
2. Shock springs
3. Fenders
4. Steering
Indicates a potential hazard that could
result in a serious injury or death.