Arctic Cat 450 i TRV/OT User Manual page 59

4. Set/Reset Button - In conjunction
with the Mode Button, sets and
resets various displays on the digital
gauge. Also used to shift from
speedometer function to tachometer
function on the
tachometer gauge.
5. Fuel Level Indicator - Indicates
approximate amount of gasoline in
the gas tank.
 NOTE: When the bottom seg-
ment flashes, approximately 3.5 L
(0.92 U.S. gal.) of gasoline remains
in the tank.
6. Low Oil Pressure - Will be displayed
during self-test at start-up. It will not
be displayed during normal opera-
tion as oil pressure is not monitored
on these models.
7. Odometer/Trip Meter - Odometer
registers the total distance the vehi-
cle has traveled. The trip meter is
resetable and can be used to measure
trip or trip legs. The odometer can-
not be reset.
 NOTE: To shift between the
odometer (ODO) or trip meter
(TRIP), press the Mode Button (3)
to select the distance mode; then
press the Set/Reset Button (4) to
select the desired display. Hold the
Set/Reset Button down to reset the
trip meter.
8. Gear Position Indicator - Indicates
which gear is selected.
• R (reverse)/N (neutral)/L
range)/H (high range).
 NOTE: An E will be displayed if
there is an error caused by a no-
shift position signal.
9. High Beam Indicator - The High
Beam icon will appear only when
the headlights are on high beam.
10. 4WD Lock Indicator - Displays
LOCK when the front differential
lock has been engaged.
11. Drive Select Indicator - Displays
4WD when selected by the drive
select switch or when the 4WD lock
is engaged. The display is blank
when in 2WD.
speedometer/
12. Speedometer - Indicates the approxi-
mate vehicle speed in miles per hour
(MPH) or kilometers per hour (km/h).
 NOTE: To change mph/km/h dis-
play, press and release Mode But-
ton (3) until the icon (MPH/km/h)
appears; then press the Set Button
(4) to change the display.
Condition Warning Display - Uses odom-
eter/trip meter display of the LCD to
warn of a system error condition requir-
ing attention.
A. Volt - The LCD will go blank
except the word VOLT will flash
on the LCD whenever a low volt-
age (< 9 DC volts) or a high volt-
age (> 16 DC volts) is detected.
When voltage returns to normal,
the gauge must be reset by turning
the ignition key to the OFF posi-
tion and then to the ON position.
B. EFI - On the 550/700 models, the
LCD will go blank except the let-
ters EFI will flash on the LCD
whenever an electronic fuel injec-
tion error is detected. After 30
seconds, the LCD will return to
normal; however, the letters EFI
will continue to flash until the
cause of the error is corrected.
C. EFI - On the 450/1000 models, the
LCD will go blank except a mal-
(low
function code will flash on the
LCD and a wrench icon will be
displayed whenever an electronic
fuel
detected. After 30 seconds, the
LCD will return to normal; how-
ever, the malfunction code and
wrench icon will continue to be
displayed until the malfunction is
corrected.
 NOTE: Take the ATV to an autho-
rized Arctic Cat ATV dealer to have
the EFI error corrected and to have
the ECU reset as soon as possible.
injection malfunction is
57