Electrolux EFC635SAR User Manual page 4

6
RANGEHOOD INSATLLATION
WARNING!
Refer to "Safety information" chapter
BEFORE INSTALLATION
Before the installation of the appliance, record the
information below from the rating plate. The rating plate is
on the bottom of the appliance casing.
Model
PNC
Serial number
DIM.A
Cooktop
type
minimum* maximum
Gas 650mm 800mm
Electric 650mm 800mm
WARNING!
Failure to install the screws or fixing device in accordance
with these instructions may result in electrical hazards
Top of hob
6 50mm 800mm
Fig6
RANGEHOOD INSATLLATION
Install the flue cover mounting and wall brackets with
screws to the wall as marked(Fig.7). Please mounted
recirculating T pieces together with flue cover bracket
if recirculating mode is used.(Fig.9)
Fig7
Depending on the preferred installation/ducting mode,
follow step 5a or 5b below.
According to the flue cover dimension, Fix the T-piece by 4
screws supplied. adhesive two sponge to the outlet of T-piece
as shown( Fig.9 )
Using the centre line, secure the recirculating T-piece and
Chimney mounting bracket to the wall. Install flexible pipe
between T-piece and flue transition duct. Use fixing ring to
secure flexible pipe to T-Piece and transition duct.(Fig.11)
NOTE: When installed in recirculating mode, it is
recommended to use a carbon filter to prevent odours
being emitted back into the room.
Fit the flexible flue to the duct transition(Fig.10).
Use fixing rings to secure flexible pipe to the duct
transition.
NOTE: For ducted mode, we recommend extanding
flue pipe through the roof to external" roof cap" to
vent exhaust externally. We do not recommend
venting into ceiling cavity.
NOTE: To ensure optimum performance of the
rangehood, the use of rigid ducting is recommended.
the use of bends should be avoided. All ducting must
be fire retardant.
sponge
7