Toro 21012 Operator's Manual page 9

© 2004 by The Toro Company
7
avarage height of lawn
normal
10,5 cm
9 cm
7,5 cm
6 cm
setting height-of-cut B - F
3.4 Attaching the grass-collecting device
1. Put the fabric of the collecting bag from behind onto the frame
(Fig. 7).
Slide the upper plastic profile underneath the handle to the
front and clip it there.
2. Clip the other plastic profiles around the frame.
3. Clip the plastic profile
3.5 Adjusting the cutting height
Adjust cutting height only when the motor
is turned off.
8
The cutting height is adjustable with a six-step central height
adjustment.
1. Push adjusting handle up until it hits the limit stop.
2. Adjust the cutting height by means of the scale keeping the
adjusting handle pressed and moving the mower up and down
(Fig. 8).
3. Release adjusting handle. The mower is locked in the
desired position.
The letters on the scale correspond to:
A = 2,2 cm
dense
D = 5,3 cm
3.6 Proper cutting height for recycling
The left rear wheel bears a scale (Smart Wheel) for reading the
appropriate cutting height (Fig. 9).
Left scale = normal grass
Right scale = dense grass
8,5 cm
Never use position "A" for recycling.
7,5 cm
6,5 cm
In easy and suitable conditions, position "B" is possible to use,
5,5 cm
recommended for recycling is "C", "D" or "E".
During the warm summer months, adjust cutting height according
to the scale "normal".
For dense, thicker or damp grass e. g. in spring, use the scale
"dense".
1. First push the mower onto the lawn - the scale must be parallel
to the ground.
2. Now you can read the length of the uncut grass on the scale
9
and choose the recommended adjustment.
B = 3,2 cm C = 4,2 cm
E = 6,6 cm F = 7,6 cm
9